Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 9 - Jul 14
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Kidde Firex 3x KF20LL Optical Smoke & 1x KF30LL Heat Alarm Kit Mains Powered with Long-Life 9V Lithium Battery Back-UpKidde Firex 3x KF20LL Optical Smoke & 1x KF30LL Heat Alarm Kit Mains Powered with Long Life 9V Lithium Battery Back Up FULLY COMPLY WITH THE NEW 2022 SCOTTISH & WELSH REGULATIONS 3x Mains Powered Optical Smoke Alarm (KF20LL): Mains Optical Smoke Alarm Features: Mains powered optical smoke alarm that can be interlinked with up to 23 other Kidde mains alarms, be they ionisation, optical or heat. Once interlinked, the detection of the relevant danger by
Kidde Firex 3x KF20LL Optical Smoke & 1x KF30LL Heat Alarm Kit Mains Powered with Long-Life 9V Lithium Battery Back-Up
FULLY COMPLY WITH THE NEW 2022 SCOTTISH & WELSH REGULATIONS
3x Mains Powered Optical Smoke Alarm (KF20LL):
Mains Optical Smoke Alarm Features:
Mains-powered optical smoke alarm that can be interlinked with up to 23 other Kidde mains alarms, be they ionisation, optical or heat.
Once interlinked, the detection of the relevant danger by an individual unit will sound across all the connected alarms.
Optical alarms are for use in escape or circulation routes and in areas where there is a danger of ignition of furniture and surroundings by cigarettes producing slow, smouldering fires.
This mains-powered unit should be installed by a qualified electrician and can be used throughout the home, except in the kitchen where a Firex Heat Alarm is recommended. These alarms comply with UK Building Regulations for new housing and associated standards (Grade D BS 5839, Part 6).
- Interlink with up to 23 Firex hard-wired alarms – all alarms sound if danger is detected
- Alarm memory – identifies source unit within interconnecting network
- Combined Test/Hush button allows regular testing of alarm function and can be used to temporarily silence nuisance alarms
- Auto reset after activation
- Tamper-resistant locking device – prevents unauthorised removal without the use of a tool
- Mains operation – 9V Lithium back-up battery supplied as standard
Mains Optical Smoke Alarm Specification:
- Model KF20LL
- Power Supply 230V mains-powered with 9V Lithium battery back-up
- Temperature Range 0ºC to + 40ºC
- Humidity Range Up to 93% Relative Humidity (RH) non-condensing
- Storage and Transport -20ºC to +60ºC and 5–95% relative humidity (RH) non-condensing
- Alarm Dimensions 127 x 127 x 39mm
- Bracket Dimensions 133 x 133 x 6mm
- Alarm Weight 242g
- Warranty 6 years
- Approvals BSI certified to BS EN14604:2005
- CE tested and certified Sensor Optical, circular lateral chamber with insect-resistant width slot entry portals and added bug screen mesh
- Chamber Size 35mm outside diameter x 16mm depth approximate (external)
- Detection Band Infrared light wavelength
- Button Test Simulates the effect of smoke within the sensing chamber, checks electronics and sounder
- Automatic Self-test Circuitry is tested and unit beeps (chirps) if fault is detected
- Supply Voltage 230V AC, 50 Hz (nominal UK voltage)
- Power Consumption < 15mA
- Connection Push-in/snap-fit type connector with 150mm long flying leads (supplied)
- Battery Back-up User-replaceable alkaline 9V battery (522/6LR61)
- Power-on Indicator Continuous green LED
- Alarm Sounder Electronic piezo-electric sounder (T3 pattern sound - 3 pulses - space - 3 pulses), soldered contacts
- Sound Output 85dB (A) minimum at 3 metres
- Alarm Frequency 3.2 kHz typical
- Dust Protection In-built foam gasket in rear of alarm to prevent dust ingress into rear of the alarm
- Alarm Status Red LED flashes approx once every five minutes = normal operation
- Red LED flashes once a second = sensing smoke (sounder alarm sounds)
- Red LED flashes once every ten seconds = in hush condition (auto-reset after 15 minutes)
- Interconnection Up to 24 Firex and Kidde ‘Slick’ units (smoke, heat and CO) can be hardwire interconnected with optional control (see below)
- Optional Controls Wired Remote Test and Hush Unit (REMTH) allows test and hush of interlinked units
- Optional Pattresses SMK23RU also has integral switchable relay for operating remote devices
- SMK4896 – Surface mounting base for added ease of installation
- Fixing Mounting bracket ring supplied with two ‘T’ slot fitting option
- 57mm spacing to a maximum of 90mm for standard screw fittings on back boxes
- Bracket has 50mm diameter central access hole for cabling
- Plastics used NORYL – Cover, main body and mounting bracket
- Lead-Free Status All Firex alarms are lead-free
1x Mains Powered Heat Alarm (KF30LL):
Mains Heat Alarm Features:
Mains-powered heat alarm that can be interlinked with up to 23 other Kidde mains alarms, be they ionisation, optical or heat.
Once interlinked, the detection of the relevant danger by an individual unit will sound across all the connected alarms.
Mains-powered heat alarms can be used throughout the home in humid or dusty environments where an optical or ionisation smoke alarm is unsuitable, e.g. kitchens, loft spaces and garages.
The Firex range requires installation by a professionally qualified electrician and complies with UK Building Regulations for new housing and associated standards (Grade D BS 5839, Part 6).
- Interlink with up to 23 Firex hard-wired alarms – all alarms sound if danger is detected
- Alarm memory – identifies source unit within interconnecting network
- Combined Test/Hush button allows regular testing of alarm function and can be used to temporarily silence nuisance alarms
- Auto reset after activation
- Tamper-resistant locking device – prevents unauthorised removal without the use of a tool
- Mains operation – 9V Lithium back-up battery supplied as standard
Mains Heat Alarm Specification:
- Model KF30LL
- Power Supply 230V mains-powered with 9V Lithium battery back-up
- Temperature Range 0ºC to + 40ºC
- Humidity Range Up to 93% Relative Humidity (RH) non-condensing
- Storage and Transport -20ºC to +60ºC and 5–95% relative humidity (RH) non-condensing
- Bracket Dimensions 127 x 127 x 39mm
- Alarm Dimensions 133 x 133 x 6mm
- Alarm Weight 213g
- Warranty 6 years
- Approvals BSI certified to BS5446 Part 2: 2003
- CE tested and certified
- Sensor Thermistor (Thermal Resistor) within detection unit
- Button Test Simulates the effect of heat at the sensor, checks electronics and sounder
- Automatic Self-test Circuitry is tested and unit beeps (chirps) if fault is detected
- Supply Voltage 230V AC, 50 Hz (nominal UK voltage)
- Power Consumption < 15mA
- Connection Push-in/snap-fit type connector with 150mm long flying leads (supplied)
- Battery Back-up User replaceable alkaline 9V battery (522/6LR61)
- Power-on Indicator Continuous green LED
- Alarm Sounder Electronic piezo-electric sounder (T3 pattern sound - three pulses - space - three pulses) with soldered contacts
- Sound Output 85dB (A) minimum at 3 metres
- Alarm Frequency 3.2 kHz typical
- Alarm Status Red LED flashes approx once every five minutes = normal operation
- Red LED flashes once a second = sensing heat in excess of 58ºC (sounder alarm sounds)
- Interconnection Up to 24 Firex and Kidde ‘Slick’ units (smoke, heat and CO) can be hardwire interconnected with optional control (see below)
- Optional Controls Wired Remote Test and Hush Unit (REMTH) allows test and hush of interlinked units
- Optional Pattresses SMK23RU also has integral switchable relay for operating remote devices
- SMK4896 – Surface mounting base for added ease of installation
- Fixing Mounting bracket ring supplied with two ‘T’ slot fitting option
- 57mm spacing to a maximum of 90mm for standard screw fittings on back boxes
- Bracket has 50mm diameter central access hole for cabling
- Plastics used NORYL – Cover, main body and mounting bracket
- Lead-Free Status All Firex alarms are lead-free
Please note: Alarms are sold individually.
Data Sheet:
Data Sheet for KF20LLData Sheet for KF30LL
Instruction Manual:
Instruction Manual for KF20LLInstruction Manual for KF30LL
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.3 ★★★★★
Based on 240 reviews
Sort
Product Reviews
★★★★★ 5
Worked well near the equator
Style: SPF 50
I bought this product because I was going to be in the field for a month, outside, every day, all day, in Tanzania at high altitude. A severe sunburn would be hard to treat in the remote area we were in, but also I am very careful about protecting my skin from aging. I had to have mineral based sunscreen because as a whitewater kayaker I know it’s the only truly water resistant kind and it was going to be sweaty. And since I knew I was going to be putting it on every day, and we didn’t have running water in the field (bucket showers only) I didn’t want it to feel gross. (I really wanted to try the spray but I didn’t want to put anything pressurized in my luggage.) And I had already discovered the Coola face sunscreen (30spf version) which had impressed me with how silky smooth and not greasy it is. Now this IS greasier because it is a higher SPF. BUT I think this product is as good as you’re going to get with the protection you’re getting. Like I said, I’m a white water tiger, so I have used a LOT of mineral sunscreens. This was hands down the most comfortable one I’ve used. And it was effective. I didn’t burn once—only time I did burn was when I forgot to put it on one day toward the end of the trip, when we were out for just a couple hours—and I got the first 2nd degree burn I’ve ever had in my life. That was what this stuff had protected me from, all day every day, the entire trip. I did tan a little but I think that was mostly from the few times I was not covered during short bouts or it was cloudy. For my face I used the Coola 50spf face product.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on August 7, 2022
★★★★★ 5
Love this stuff!
Style: SPF 50
I use this every day and I love how it is frangrance free and creamy. I have a very fair complexion and I will say it leaves a slight white cast but it doesn’t bother me because it almost makes my fairness more creamy looking. My skin texture has improved since wearing it daily and no allergies from it. I highly recommend especially if you have fairer skin otherwise it may leave a cast .
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 19, 2023
★★★★★ 5
Excellent mineral sunscreen with minimal white cast.
Style: SPF 50
This is one of the healthier sunscreens I’ve found so far. You’re not likely going to find a mineral sunscreen that doesn’t leave some white cast. However, this one rubs in pretty good with minimal cast.
You can dab on and rub in fairly easily… as long as you don’t use too much the white cast should be minimal. I am not sure how well this would work on darker skin tones. My arms are a medium skin tone… my legs are more of a light-medium tone.
I prefer mineral sunscreens, and this is the best one I found so far and compatible to Supergoop mineral play. If you liked that one, you would likely enjoy this Coola one too.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 25, 2025
★★★★★ 1
Would not recommend
Style: SPF 50
I literally never write reviews but felt compelled to write one for this sunscreen because I was very caught off guard by all the positive reviews. This sunscreen leaves the most insane white sheen that never soaks in and gets on EVERYTHING. I put this on and drove to the beach and had sunscreen on my car seat, the steering wheel, the center console, the door, EVERYWHERE!
It took forever to clean up and was such a hassle and that was after having let the sunscreen soak into my skin for an hour.
Also the sunscreen is really thick and difficult to spread and makes you look ghostly white. Plus, the sunscreen has a really odd odor that reminded me of play dough? That might not be a negative thing for everyone but I found it unpleasant.
There are definitely better mineral sunscreens out there. For the price I expected a much better product.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 11, 2025
★★★★★ 3
Sticky and white
Style: SPF 50
The sunscreen has a very sticky and thick texture. It will keep you from getting sunburnt, but it will also leave you with a white color.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 22, 2024