Pay in installments of $136.88 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 16 - Jul 21
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Apex Chassis KIT125 2.5 Ton Tie Rod and Drag Link Assembly - Polished Aluminum 18-23 Jeep Wrangler JL JTTired of sloppy steering and weak stock components? Upgrade your Jeeps handling and durability with the KIT125, a complete replacement steering system built to handle the toughest off road conditions. With massive 2" 7075 T6 polished aluminum rods and forged steel ends, this kit replaces the "wet noodle" feel of stock steering with race grade strength and precision. This kit can be configured as an under knuckle mount (standard) or over knuckle mount
Tired of sloppy steering and weak stock components? Upgrade your Jeep’s handling and durability with the KIT125, a complete replacement steering system built to handle the toughest off-road conditions. With massive 2" 7075-T6 polished aluminum rods and forged steel ends, this kit replaces the "wet noodle" feel of stock steering with race-grade strength and precision.
This kit can be configured as an under-knuckle mount (standard) or over-knuckle mount (flip kit). All flip kits include the taper sleeve. Under-knuckle is recommended for lifts of 4.5" or less, while flip kits are suggested for lifts over 4.5" to maintain proper steering geometry and reduce bump steer.
Please note: the steering stabilizer bracket is not included and must be chosen separately based on your stabilizer setup.
View No Flip Instructions Here
Fitment Notes:
- Fits 2018–2025 Jeep Wrangler JL and 2019–2025 Jeep Gladiator JT with stock Dana 30 or Dana 44 axles.
- To determine if you have a Narrow or Wide Dana 44 axle, measure your tie rod from ball stud center to center: ~61" = Wide, ~58" = Narrow (select Dana 30 option for Narrow axle vehicles, typically non-Rubicon/Sport/Mojave/MaxTow models).
- Taper sleeves require drilling the knuckle drag link mount with a straight 7/8" drill bit.
- If using AEV or stock Rubicon wheels, a 1.5" spacer may be required. Works with 17" wheels with ≤4.75" backspacing.
- Wrenches needed: 46mm x 2 for jam nuts, 19mm for castle nuts.
FEATURES:
- Polished Aluminum Rods: 2" 7075-T6 aluminum rods for extreme strength with minimal weight.
- Forged Steel Ends: Tie rod and drag link ends built for maximum durability.
- Flopper Stoppers: Prevent tie rod and drag link rotation; 27° swing left/right, 2° forward/back.
- Ninja Lock Washers: Secure, no-slip setup without weak pinch clamps.
- CR Rubber Boots: Protect bearings from dirt, water, and debris; accordion design for high articulation.
- Rugged Metal-to-Metal Bearings: Long-lasting and precise performance.
- Pre-Greased & Greaseable: Easy maintenance with gull wing grease grooves for even lubrication.
- High-Quality Hardware: Grade 8 Class 10.9 bolts and castle nuts for superior strength.
- Adjustable Tie Rod & Drag Link: Allows proper alignment setup for your Jeep.
- Flip or Standard Mount: Choose an under-knuckle or over-knuckle flip kit depending on lift height.
- Minimum Engagement Mark: Indicates safe thread engagement on drag link ends.
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.6 ★★★★★
Based on 28 reviews
Sort
Product Reviews
★★★★★ 3
Great idea but didn't hold up!
Size: Large
My dog and I really enjoyed this as a tug toy to use where it kept my hands away from accidental nips. When we initially got it we let her play solo with it after our tug session and I noticed that she left little teeth puncture holes so we packed it away for awhile and exclusively used the other new toy we bought for her. After a few weeks we took this back out and, again, we loved it and this time I allowed her to play with it longer and although it was showing a lot of the little tooth marks it seemed to be holding up so I left it out with her. None seemed deep, just seemed like impressions from her teeth.
We continued to enjoy it for about a week where she'd carry it over to us for tug sessions, loop it on our feet when we were sitting watching tv and chewing on it a bit. I'd look at it when we'd tug and, like I said above, it seemed to be holding up. After one session of tug when she took it off to chew on and I was watching some tv I checked on her after awhile and she had bitten through the black side and had chewed up into small pieces about a two inch section of it. Small, little hard bits were in a pile on the floor. She didn't just bite through, it had broken into small, little pieces and hopefully I was able to get all of them and she didn't swallow any!
So if you want to get this exclusively as just a tug toy and not something for your dog to chew on and plan on putting it away after I think it will be okay for that and should last but if your dog is a serious chewer like ours is you may not want them to be allowed to chew on this. Seemed like it was going to last and then suddenly I was throwing away half of it and hoping she didn't eat any of the black bits. We still have the yellow side and will take that out for some tugging but no longer for her to play with freely!! She did tremendously love running around with this thing and would flip up the loose end and hook it on her face or our feet and was so cute to watch her!! Wish it had lasted!!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 9, 2013
★★★★★ 5
Name holds true.
Size: Large Triple
Just bought my second set of these.. first set lasted my healer almost 4 years and are still together but starting to split at the smaller seams so you can’t play as aggressive as my dog would like. We bought the second set and now she has her second wind! She loves tugging and I love knowing this toy will last a good while especially with an active dog!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 4, 2025
★★★★★ 5
My Aussie loves this bone!
This wishbone is so durable! My Australian shepherd is a big cheese and this is her go-to chew toy. It's a fave! She has spent HOURS chewing on this bone and it has held up super well. It has no smell but understand she can taste the flavor of it. I love having something she can chew on that is safe for her that she enjoys. Great value.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 10, 2026
★★★★★ 5
Durable, Great Value Dog Bone!
We’ve ordered several of these that have lasted for months, and my dogs are still working on them. Months. That alone feels like a small miracle. Normally, chews last about 10 minutes. Not this one. This thing is built like it trained for battle. It keeps them busy, satisfied, and focused on something that is actually meant to be chewed.
And the best part? It’s way more affordable in the long run. Instead of constantly buying new toys, chews, or replacing destroyed shoes, this one just keeps going. Definitely worth every penny and then some.
If you have determined chewers, this is the chew/bone you’ve been looking for.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 18, 2026
★★★★★ 5
Dog loves this
My dog absolutely loves the shape of these and will play with it for hours. The material is pretty durable too, though he is a big lab so over time chewed away the top nubs. Eventually tossed it at that point, but got great use out of it before. No bad smell and my pet really enjoys playing with it. It’s not too big either and is really easy to take with you on trips, etc. have bought multiple!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 17, 2026