TrueRC “X” ANTENNAS SET FOR DJI FPV

TrueRC “X” ANTENNAS SET FOR DJI FPVInstallation Place the X AIRs on the goggles following a X pattern: Bottom left: LHCP Top left: RHCP Top right: LHCP Bottom right: RHCP Specifications Gain (X AIR): 9. 5 10. 5 dBic Gain (OCP): 1. 6 dBic Polarization: RHCP and LHCP Beam width* (X AIR): 120deg Beam width @ 3dB** (X AIR): 68deg. *Coverage where reception is at least equivalent to an omni. **Coverage where at least 70% of the max range is obtained. Includes 2x RHCP X air 5. 8 MK. II 2X

Installation

Place the X-AIRs on the goggles following a X pattern:

• Bottom left: LHCP
• Top left: RHCP
• Top right: LHCP
• Bottom right: RHCP

Specifications

• Gain (X-AIR): 9.5-10.5 dBic
• Gain (OCP): 1.6 dBic
• Polarization: RHCP and LHCP
• Beam-width* (X-AIR): 120deg
• Beam-width @-3dB** (X-AIR): 68deg.

*Coverage where reception is at least equivalent to an omni.
**Coverage where at least 70% of the max range is obtained.

Includes

• 2x RHCP X-air 5.8 MK.II
• 2X LHCP X-air 5.8 MK.II
• 4X 45deg low-loss RP-SMA adapters
• 1x RHCP OCP with MMCX90 connector
• 1x LHCP OCP with MMCX90 connector

Useful print!

• X tie brace

If you dont have a printer, we can print one for you using our 3D print service

FAQ

Can I use something other than the OCP with MMCX90 connector on the airunit?

-"Yes, if you have pigtails you can use antennas with SMA. Leave a comment while ordering and we can swap for the connector type you need."

Can I use this with the vista unit?

-"Yes, however the performances wouldn't be as good as they could be with an airunit."