Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 11 - Jul 16
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Awave DSP-6V4 6-channel amplifier with 8-channel DSPA compact 6 channel amplifier with an 8 channel DSP. 4 channels of RCA inputs, 6 high level inputs, coax SPDIF input, optical TOSLINK input, Bluetooth AptX HD optional input, optional digital remote control for volume, sub level, preset selection, input selection, mute trigger. 6x80W RMS @ 4 Ohm output channels, 8 channel RCA output. Perfect for 3 way active front + external subwoofer amplifier or 2 way active front, passive rear fill and external
A compact 6-channel amplifier with an 8-channel DSP. 4 channels of RCA inputs, 6 high-level inputs, coax SPDIF input, optical TOSLINK input, Bluetooth AptX HD optional input, optional digital remote control for volume, sub level, preset selection, input selection, mute trigger. 6x80W RMS @ 4 Ohm output channels, 8-channel RCA output. Perfect for 3-way active front + external subwoofer amplifier or 2-way active front, passive rear fill and external subwoofer amplifier. A simple, yet powerful DSP amplifier able to run modern active SQ systems without hassle.
The DSP supports the following on every output channel:
- High pass, low pass and band pass crossovers (Linkwitz Riley, Bessel and Butterworth) up to 48 dB/oct
- 31 band fully parametric EQ with +/-15 dB correction
- Time delay up to 15 ms for time alignment, selectable in ms, cm or inches, optional linking of channel pairs
- Phase phase switching between 0 and 180 degrees
- Level correction from 0 to -40 dB, optional linking of channel pairs
- Fully functional input mixer, switching of the input channel phase to 180 degrees, allowing for the set up of a differential rear fill
- Internal pink noise generator to test each individual output channel
Configuration software for Microsoft Windows: DOWNLOAD HERE
Manufacturer provided specs:
- Power supply voltage: 9-15 VDC
- Idling current: 1.5A
- Bandwidth @ -3 dB: 10Hz-20kHz
- Output power at 1% THD-N: 6x 80W RMS @ 4 Ohm
- S/N Ratio full power A-: 100dB
- Inputs: 4xRCA analogue, 1x RCA SPDIF coax, 1x TOSLINK SPDIF, 6x high-level, optional Bluetooth 5.0 AptX HD module
- Outputs: 8x Speaker level amplified, 8x RCA pre-outs for all channels
- Control connections: 1x USB 1.1/2.0, optional wired remote (DRC)
- 8 full setup presets
- Auto on via high level signal detect or remote input
What's included:
- 1x DSP Amplifier unit
- 5m USB A-B cable
- 1x High-level input harnesses
- 1x Speaker output harnesses
- Mounting brackets and fasteners
- 1x Instructions
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.6 ★★★★★
Based on 177 reviews
Sort
Product Reviews
★★★★★ 5
Quality product
Seeing as it passed the smog test without any issues, it seems this product worked exactly as intended.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 20, 2026
★★★★★ 5
So far so good
It seems to be working well, so far. The check engine light turned off and the my vehicle seems to be running well. Be sure to follow the instructions. A while back, I wasted some money on a different catalytic converter cleaner because I put the cleaner in on a full tank of gas. It's best to wait until you're at a half tank or less of gasoline before you put in your catalytic converter cleaner. Also, I drove around right after I put in the catalytic converter cleaner and before I filled up my tank again. A couple of days later, I went to the gas station and topped off my tank. Again, it seems to be running well for now.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 21, 2026
★★★★★ 4
Works ok for some stuff.
I tried this mainly to clean my cats. It sadly didn't work for that at all.
It did however work great as a basic fuel system cleaner. It smoothed out my idle and cleaned my O2 sensors they were a bit lazy before using this product now they switch fast like they are supposed too.
In terms of my recommendation I say use as a fuel system cleaner. Or if your cats aren't too clogged in my case I bought an old neglected used car that likely had that problem for years. So I don't think any pour in tank cleaner would work in my case.
However if your car just started having cat issues. This might work??
I think it's worth a try at least and isn't much more expensive than a basic fuel system cleaner so why not?
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 16, 2026
★★★★★ 5
PASSED MY INSPECTION! THIS PRODUCT WORKS LIKE A MIRACLE DONT HESITATE TO BUY IT!
Inspection on my car due the end of January! My check engine light was coming on so I checked with a code reader & found it was a P0420. Read about the Catalytic Converter System possibly being in need of replacement or perhaps clogged. I am a woman, and know next to ZERO about cars, but I can read. Did investigate and found that the replacement of a Catalytic Converter system is mad expensive- also found this Moly Cleaner to add to gas tank. I'm not going to lie; I was nervous as I have a Kia Rio 2014 that has a very small gas tank and gets great gas mileage. In reading the consensus seemed to be to add to 1/4 tank of gas and drive fast for good periods of time to blow out the clog (if it was a clog). Did I mention I live in NYC and driving for long periods of time at high speeds can be a problem because of terrible traffic. Anyhow, this Saturday I poured the can into my 1/2 filled tank and hit a parkway near my home early morning. I did drive for 45 miles sometimes at 80mph then 60mph but tried to do it for a good few minutes at a time without getting pulled over. Checked my reader again, and it was not quite ready but the engine light did stay off. Next day, drove to work, stuck in traffic somewhat & never made it over 20mph & checked my reader again- all good to go for inspection. Went last night- my car PASSED and got that sticker in my window- so I am good for another year. The BEST money I have spent all year. Thank you for carrying this product! Saved me thousands! DONT HESITATE TO USE THIS. The hardest part for me was removing the cap on the can!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 13, 2026
★★★★★ 5
Great stuff
Seemed to work as well as or better than some more expensive catalytic converter cleaners. I put it in while at 1/3 tank and my Check Engine light went out almost immediately once I started driving. My Tundra has almost 230,000 miles and still runs great but was getting a little harder to start after I switched from full synthetic oil to conventional. I’ll never do that again and immediately switched back but the damage was done. Check engine light came on and I had to crank longer to get it started. Adding this Liquid Moly fixed both issues temporarily. I have to wonder if this was used regularly, say every 3 months, if it would clean the catalytic converter more permanently?
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 29, 2025