PRO-TECH DRAWER PULL 1/2 SHANK KP853

PRO-TECH DRAWER PULL 1/2 SHANK KP853Drawer Pull Finger Grip Carbide Tipped The drawer pull bit produces a smooth finger grip primarily used on the bottom edge of drawer fronts. Also used as a finger pull on cabinet doors where no edge pattern is needed on the front face. Compatible with CNC and table mounted routers. Industrial grade micro grain tungsten carbide This router bit has a 12. 7mm shank (shaft) that will fit most large routers. Please ensure that you select a router bit with

Drawer Pull / Finger Grip

Carbide Tipped

The drawer pull bit produces a smooth finger grip primarily used on the bottom edge of drawer fronts. Also used as a finger pull on cabinet doors where no edge pattern is needed on the front face. Compatible with CNC and table mounted routers. Industrial grade micro grain tungsten carbide

Use these flush trimming bits for laminate work or for template and pattern work. This router bit can be applied to either cut the edge of the workpiece or make a groove through the material as shown in the picture. We recommend that you first cut a groove with a straight bit before grooving with this router bit.

PRO-TECH router bits are manufactured in Taiwan.

Router Table Safety

Although most router bits are small, they can be potentially dangerous and should deserve your attention and respect.

1 Use push sticks or a push block to position your hands a safe distance from the router bit.

2 Use large-diameter bits only in a router table. Using bits over 25mm Ø (diameter) in a handheld router can possibly cause you to lose control of the tool and harm yourself or bystanders.

3 Always wear a dust mask as well as eye and hearing protection.

4 Take light cuts. Heavy cuts invite kickback. If necessary, move the fence closer to the bit or switch to a larger guide bearing/bush.

5 Use a featherboard (anti-kickback device) to support the workpiece against the router table and/or fence.

6 Never climb-cut. Always feed the stock from right to left. Against the rotation of the router bit. (see illustration)

7 Avoid routing small stock. Instead, rout a larger piece and cut it to size afterwards. If you absolutely have to profile a small piece, build an suitable jig or secure the workpiece.

8 Always use a guard. If the fence didn t come with a guard, make your own.

9 Never start the router with the bit in contact with the material.

10 Don t force the router bit or overload the router. Excessive heat is an enemy.

11 Secure/fasten the router in the base before starting/switch on the router.

12 Don t bottom out the bit in the collet or partially insert the bit. Instead, completely insert the bit, and then back off approximately 2 mm. At least ²/₃ 's of the router bit shank should be inside the collet.

13 Be sober and not under the influence of medicine that causes a lack of concentration

14 Tidy up your workshop to ensure the ability to move freely with enough room around the router table

Length of Shank: 38 mm